BIOS The BIOS on the DFI LANParty DK P55-T3eH9 follows the same lines as the rest of DFI's boards, with one thing that is a little different being the CMOS Reloaded menu. Normally you have a listing of the banks available for you to save to or load from, but this is not visible in the T3eH9 until you open the Genie BIOS option. Another item that is odd is that when you save current settings we did not see an option to save to a particular bank and all banks remained the same (one single one describing a 166MHz BClk and the rest listed as blank).

BIOS CHIP DFI LANPARTY DK P55-T3EH9, DK 790FXB-M3H5, DK P35-T2RS, DK X48-T2RS. Save dfi p35 to get e-mail alerts and updates on your eBay Feed. Cor Crane Secret Polvo Rar more.

As with the DFI GF9400, I ran into the now familiar problem with resetting the BIOS on the T3eH9. I had to completely power down the board (remove the PSU connectors) and pull the battery. This was the only way the BIOS would reset. The DFI BIOS is very hardy, but at times this can become a real inconvenience. BIOS Secure Here things get very interesting.

BIOS secure, as we mention above, is a method for flashing the BIOS on the LP DK P55-T3eH9 no matter what the state of the current BIOS. You do not even have to have it powered on for this flash to work. There is a little bit of a setup, though. To run this you need a second system. We used an MSI Wind 200 running Windows 7.

The first thing you have to do is plug in the included USB cable. Fly Fishing Simulator Keygen Music. This will open up the 'install new driver' dialog, but will fail because Windows 7 does not have the needed drivers. Overclocking Overclocking the LANParty DK P55-T3eH9 was not the treat I was expecting. I was unable to get even close to the max OC that I have run on the i5 750 that I have been using.

It is capable of running at 4.3-4.4 stable, yet on the T3eH9 we only saw 4.214GHz; this was at 210x20. There was (oddly enough) no direct option for turning turbo mode on or off. Rapidshare Old Ideas Leonard Cohen there. This could be the reason that my higher overclocks failed as the turbo mode on the Core i5 and i7 can cause instabilities during overclocking when left on. You can see the validation.